audi a4 default code 005660 glowplug for cylinder 3

How dare the Law prohibit hashish and heroin yet license your use, who inflate all weak inferior egos? Their addicts only do harm to their own lives: you poison the lungs of the innocent, your din dithers the peaceful, and on choked roads hundreds must daily die by chance-medley. PM me your email and the cars reg number and I will mail over the info.ĭark was that day when Diesel conceived his grim engine that begot you, vile invention, more vicious, more criminal than the camera even, metallic monstrosity, bale and bane of our culture, chief woe of our Commonweal. I have the tool next to me as I am just about to use it. Yes there is a huge and expensive special tool for fitting the rear crankshaft ring/seal assembly and it is a painful and exacting process to fit it. Is there a set gap for the sensor / rotor or procedure for fitting the crankshaft sensor and rotor to the rear of the crankshaft or am I missing something stupid ? Has anyone had thie fualt before ?Īny help would be greatly appreciated on this one, Thanks, Euan. Been pulling whats left of my hair out all day over this one. vehicle will not start with crank shaft sensor plugged in but when you disconnect it it will turn over for approx 3-4 seconds then start, idle and take throttle.When engine is running the crankshaft speed registers 920 rpm when idling but the camshaft speed does not register.

on cranking the Crankshaft speed is registering 270 rpm and the camshaft speed is registered 135 rpm. Have checked the wiring from the sensor back to the ECU and everything checks out OK. P0322 : Crankshaft position sensor / vehicle speed sensor no signal.Ī new sensor was supplied and fitted with engine. Problem is the glowplug light flashes on and off constantly, carried out diag check and code P0322 is stored and can't be cleared. The engine will crank for 3-4 seconds then burst into life and run fine.

Have fitted a reconditioned engine to the vehicle due to oil pump failure. engine code BLB in with us at the moment.

Audi a4 default code 005660 glowplug for cylinder 3